Submitted on 2012/04/23 at 3:21 pm Kool looking wagon. What shocks did you use(DJM/Calmax part #’s)? I have a 1991 Caprice wagon with the 305TBI. Do these use the same shocks? Thanks, RED Submitted on 2012/05/11 at 8:35 am | In reply to Red. Red, We used our part number “1315″ on the front with…
Submitted on 2012/05/04 at 10:32 pm I wanna use drop spindles and lower arm controls on my tahoe 1996 to get to the lowest drop possible is it ok to use a setup like that? Omar Omar, You can use either drop spindles or Calmax control arms but not the two together. The spindles give…
Submitted on 2012/05/09 at 12:37 pm I bought a ’91 S-10 with a V8 conversion that has already been dropped but there’s only about 1″ of suspension travel in the front before it hits the bump stops. It looks like the A-arms are a good way to go but what springs do you recommend? Or…
Submitted on 2012/03/21 at 6:32 am I want to lower my 2004 4WD chevy Tahoe with a DJM 3/5 complete lowering kit. Most people say it’s impossible ~ I’ve discussed with custom truck shops and they tell me it is POSSIBLE! Can I order the 3/5 lowering kit or does it have to go through…
Submitted on 2012/02/29 at 2:51 pm I just installed your drop spindles with 3 inch dropped springs in the front. I also did the rear flip kit for 6.25 inches of drop. I have a 1995 GMC reg cab short bed 2wd. Rides great, but I had to trim the factory lower control arms way…
Submitted on 2012/02/17 at 8:40 pm I have an 08 silverado. i had installed a 3-6 kit about a year ago. i now have a problem with the front end of the suspension “creeking” and “grinding” real bad going over bumps or pulling out of drive thru’s. what could this possibly be and what do…
Submitted on 2012/01/26 at 9:28 pm I have a 1979 f100 429ci. Im wanting 2 get lowerd. I dont want to use the i beam system anymore. is there any other kit available , or what can i modify to fit? i plan on using air bags eventually. Any ideas? the rear will be 4…
Submitted on 2012/01/06 at 5:56 pm Hi, i have a 88 ford ranger it has a 350 C.I chevy engine in it and i was wondering if your DJM front springs could handle the extra weight i also want to put a flipkit on the back with some wide slicks to give it more of…
Submitted on 2012/01/06 at 2:20 pm I have 2002 ext cad chevy truck with the 2/4 drop with control arms and hangers and shackles. I want to know if can use stock shocks up front with the control arms? next question is my pinion angle is not after the lower kit.I do have a 2…