Submitted on 2012/01/26 at 9:28 pm I have a 1979 f100 429ci. Im wanting 2 get lowerd. I dont want to use the i beam system anymore. is there any other kit available , or what can i modify to fit? i plan on using air bags eventually. Any ideas? the rear will be 4…
Submitted on 2012/01/06 at 5:56 pm Hi, i have a 88 ford ranger it has a 350 C.I chevy engine in it and i was wondering if your DJM front springs could handle the extra weight i also want to put a flipkit on the back with some wide slicks to give it more of…
Submitted on 2012/01/05 at 5:30 pm I too am wanting to lower my 1980 F100 stepside. I am doing a total frame off. PLease let me know if you have a kit that I can use. Clark Submitted on 2012/01/06 at 8:19 am | In reply to Clark Patton. Clark, We need to find out…
Submitted on 2011/11/12 at 11:10 am I have an 81 F-100 4×2 short flareside and need to know easiest way to use your 84-86 DB 3003-3 beams and still retain my early F-100 4.5 bolt circle rotors and brakes. For example, can my kingpin 81 spindles be machined to take the 3003-3 ball-joint axles ?…
Submitted on 2011/07/31 at 8:41 pm I’m prepping to install the 3/4 drop on my 95′ ranger and I’m almost 3/4″ lower on the driver’s side. I want this to be level at all times. What shims should I use to correct this? Could you give me a part number for it? Thanks Tommy Submitted…
Submitted on 2011/07/04 at 2:40 pm Vehicle 1979 f150-ordered a 5inch flip kit for rear and 3inch I beams for front was told it would be plenty. But after installing shocks in the front I got an inch and a half of lift, the front sit 2inches higher than the back need to get it…
Submitted on 2011/05/03 at 11:14 pm I am having a little problem and hope you can help, I have approx a 1970 f100 short wheel base truck which has had a later model disc brake front end put on it. I wish to purchase the DJM lowering kit dream beams, spring hangers, shocks etc but…
Submitted on 2011/05/02 at 8:15 am What adjustments will I need to make so the drive shaft will not cause trouble on my 2011 f-250 reg cab 2×4 . If I use the F250 2011 full kit. will I need to do anything with the differential geometry. Jim Submitted on 2011/05/02 at 2:14 pm |…
Subject: dream beams To: DJM Suspension <tech@djmsuspension.com> Conversation: dream beams Will your dream beams work with on a 1963 ford F100? William William, I am sorry to say our “Dream Beams” will not work on your 63 F-100. Our beams start with the “Twin I-Beam” front end introduced in 1965 by Ford. We do have…